How much surface area will the RemovALL strippers cover?

10th November, 2009 - Posted by Meccanator - No Comments

Depending on the amount of layers you’re trying to remove, RemovALL will cover anywhere from 40-90 sq ft per gallon (1 to 2.2 sq.m/Litre). Read More

Can I brush RemovALL paint remover on?

10th November, 2009 - Posted by Meccanator - No Comments

You can brush on the following products: RemovALL 220 RemovALL 320 The rest of the paint removers have a gel consistency and require airless sprayer application. Read More

How do I know if the RemovALL product is working?

10th November, 2009 - Posted by Meccanator - No Comments

After applying the product to the surface, you should notice tiny little bubbles forming on the top of the surface. When you see those, you know it’s working. The RemovALL products are based on SARA technology (Selective Adhesion Release Agent), which works by releasing the bond between the coating(s) and the substrate (surface). Read More

How much paint will the RemovALL remove?

10th November, 2009 - Posted by Meccanator - No Comments

Depending on the type of paint, the RemovALL products will remove anywhere from 3-9 layers of paint. The product must be applied one and a half to two times the thickness of the coating you’re trying to remove. You should simply not be able to see your underlying paint. Read More

How long does RemovALL take to remove paint?

10th November, 2009 - Posted by Meccanator - No Comments

The best way to determine this answer is to do a test area. Apply the stripper on a small area of your project. This will tell you exactly how the stripper will perform and how long it will take. The time really depends on what type of coating you’re trying to remove and how many » Read More

RemovALL didn’t take off all the paint. What now?

10th November, 2009 - Posted by Meccanator - No Comments

There are a few reasons why this may happen. You might have applied too little of the RemovALL paint stripper. The paint absorbed it all and it stopped working. Remember that you should not be able to see your underlying paint after you have applied the paint remover. Your project was in the direct sun » Read More

Do I need to do anything after using RemovALL?

10th November, 2009 - Posted by Meccanator - No Comments

After the coating has been removed, a simple rinse with water will neutralize your surface. You do not need any other chemicals to neutralize the product. Neutralizing is necessary if you are going to re-apply paint to your project. Read More

Do you have a product to remove JFB Hart Coatings GlossTek?

5th November, 2009 - Posted by CK - No Comments

DoradoStrip 3032 can remove the GlossTek™ coating from floors primarily through SARA “ the technology behind the product “. This removal method is used primarily within the janitorial industry as it does not damage Vinyl Composite Tile or (VCT). Read More

What product do I use to strip Cedar clapboard siding?

4th November, 2009 - Posted by CK - No Comments

DoradoStrip 3031.  Learn more here. Read More

Where did the RemovALL product go?

3rd November, 2009 - Posted by CK - No Comments

The Global rights of the Canadian manufacturer Napier Environmental Technologies was acquired by Freeworld Coatings Global a paint manufacturer with head offices in South Africa.  At present we are unable to submit resupply orders for the RemovALL product but hope to be able to bring the product back to market by Spring/Summer 2010. In the » Read More

Older Entries