10th November, 2009 - Posted by Meccanator - No Comments
Depending on the type of paint, the RemovALL products will remove anywhere from 3-9 layers of paint. The product must be applied one and a half to two times the thickness of the coating you’re trying to remove. You should simply not be able to see your underlying paint. Read More
10th November, 2009 - Posted by Meccanator - No Comments
The best way to determine this answer is to do a test area. Apply the stripper on a small area of your project. This will tell you exactly how the stripper will perform and how long it will take. The time really depends on what type of coating you’re trying to remove and how many » Read More
10th November, 2009 - Posted by Meccanator - No Comments
There are a few reasons why this may happen. You might have applied too little of the RemovALL paint stripper. The paint absorbed it all and it stopped working. Remember that you should not be able to see your underlying paint after you have applied the paint remover. Your project was in the direct sun » Read More
10th November, 2009 - Posted by Meccanator - No Comments
After the coating has been removed, a simple rinse with water will neutralize your surface. You do not need any other chemicals to neutralize the product. Neutralizing is necessary if you are going to re-apply paint to your project. Read More
10th November, 2009 - Posted by Meccanator - No Comments
RemovALL products work the best with sprayers that are higher grade/industrial-based. Sprayers such as those made by Titan, Graco (nothing smaller than a Graco 495 model) and Lemmer work well with the RemovALL products. Beware of lesser quality sprayers sold at large retail stores. (See application instructions for further information) Read More
10th November, 2009 - Posted by Meccanator - No Comments
For metal or plastic surfaces (non-porous) or painted porous surfaces, RemovALL 400 spray should take care of the problem. Read More
10th November, 2009 - Posted by Meccanator - No Comments
According to the technical staff RemovALL 510 is recommended for this task. RemovALL 610 is used for anti-fouling paint removal. Auto finishing’s are generally too tough for RemovALL 610 to penetrate. The fiberglass issue does have some variables however, because not all fiberglass is the same or in the same condition. Technical Support encourages those » Read More
6th November, 2009 - Posted by Meccanator - No Comments
Yes. The Scratch Removers are designed to work with the existing finish or varnish. We have been selling them to furniture factories and cabinetmakers since 1950. Use the Dark Scratch Remover for darker colors like walnut, mahogany and cherry. Use the Light Scratch Remover for lighter finishes like maple, oak and pine. Read More
6th November, 2009 - Posted by Meccanator - No Comments
Yes. Apply the Scratch Remover to the surface and allow to dry for 15 to 30 minutes. Wipe off any excess material. The result will stay that way for many years. Read More
6th November, 2009 - Posted by Meccanator - No Comments
Trade Secret is highly concentrated and lasts up to 5 times longer. The staining action penetrates deeply into the surface and won’t discolor with age. It’s easier to apply and tested to work with virtually any finish including shellac, varnish, lacquer, polyurethane and even French Polish. Read More